Splice Adhesive

3.78L Tin

Firestone Splice Adhesive is a contact adhesive, designed for splicing EPDM.

Preparation

Surfaces to be adhered must be cleaned with Firestone Splice Wash and allowed to dry. Stir the adhesive thoroughly before and during use, achieving a uniform mix with no sediment on the bottom and no marbling evident. Restore the adhesive to room temperature prior to use, if exposed to temperatures lower than 15 degrees for a prolonged period.

Application

Apply a thick, even, smooth coat on both surfaces using a 75 - 100mm wide solvent resistant paintbrush. Do not use circular motions for applying Splice Adhesive, do not use paint rollers or a brush attached to a long handle. Allow the adhesive to flash off prior to mating the surfaces (flash-off time depends on ambient air conditions). Test the adhesive for its dryness, using the push-touch procedure.

Coverage

A uniform application is required to avoid mixed results. Coverage rate for a standard splice width of 100mm, both sides is 30lm per 3.78 Litre tin.

Precautions

Flammable. Keep away from sources of ignition. Do not smoke when using. For professional use only. Use only in well ventilated areas. Avoid contact with skin and eyes. Keep out of the reach of children.

See our download section for installation details.