Firestone Bonding Adhesive

(BA2004)

 Description

Firestone Bonding Adhesive BA 2004 is a neoprene based contact adhesive designed for bonding EPDM membranes to wood, masonry, metal and other acceptable substrates.

Preparation

Surfaces on or against which Bonding Adhesive is to be applied must be clean, smooth, dry and free of sharp edges, loose materials, oil, grease and other contaminants. The mating surface of the membrane shall be cleaned with a brush or clean rag. Stir the adhesive thoroughly before and during use, achieving a uniform mix with no sediment on the bottom and no marbling evident. Restore the adhesive to room temperature prior to use, if exposed to temperatures lower than 15 degrees for a prolonged period.

Application

Apply adhesive in an even, smooth coat on both surfaces with a solvent resistant roller. Avoid globs and puddles. Allow adhesive to flash off until tacky (time depending on ambient air conditions) prior to mating the surfaces. Test the adhesive for its dryness, using the push-touch test procedure as described in the installation guides.

Coverage

The Adhesive must be applied at a uniform rate to both the membrane and the roof substrate. Coverage rates depend on smoothness of substrate and method of application.

1 Litre Tin - approx 2m2

2.5 Litre Tin - approx 5m2

5 Litre Tin - approx 10m2

10 Litre Tin - approx 20m2

Storage

Store in original containers at temperatures between 15 - 25 degrees. Keep the material out of direct sunlight until ready for application.

Shelf life - 12 months, when stored in above-mentioned conditions.

Precautions

Flammable. Keep away from sources of ignition. Do not smoke when using. For professional use only. Use only in well ventilated areas. Avoid contact with skin and eyes. Keep out of the reach of children.